Cosa-xentaur Xentaur XDTL-HT Manuel d'utilisateur télécharger pdf (Page 14)

Interfacing to RS-232/RS-485

Depending on the ordered configuration, the

XTDL-HT™ supports RS-232 or half-duplex RS-485

serial interface option. The serial cable should be

fed through one of the cable grips (fourth cable

grip is recommended). For RS-232, TxD, RxD, and

Common Ground signals should be wired to the

DIN-mounted terminal blocks marked 11, 12, and

13, respectively. For RS-485, the inverting signal

(TxD-/RxD-) should be wired to the terminal

block marked 11, non-inverting signal

(TxD+/RxD+) to the block marked 12, and

common signal to the block marked 13. Isolation

option is available on either interface. Refer to

Modbus RTU section for setup information.

Interfacing to Ethernet

To use the optional Modbus/TCP communication,

Ethernet cable once fed through a cable grip (first

cable grip is recommended) should be hooked up to

the RJ-45 connector on the Control Board. Make

sure that there is enough cable slack to allow the

door fully opened. Cat-5 or compatible cabling

should be used. Refer to Modbus/TCP section for

setup information.

Serial cable installation

Ethernet cable installation

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

Pas de commentaire

Cosa-xentaur Xentaur XDTL-HT Manuel d'utilisateur Page 14