Cosa-xentaur Xentaur XDTL-HT Manuel d'utilisateur télécharger pdf (Page 13)

Installation

Connecting Power

The XTDL-HT™ requires AC power of 110/230VAC, 50/60 Hz. The voltage rating should be specified on

the order and it is marked on the front panel label. Each instrument is provided with an international

approved AC power cable, terminated with a connector according to the ordered option. This cable is

provided strictly for testing the instrument; it should not be used in the final installation. For

installation, the instrument must be field wired permanently connected and installed according to local

and nationally recognized procedure for equipment of this type and stated power requirements. For

North American installations, use UL 62 and/or CSA C22.2 No 49, 16AWG cable with black, white, and

green color codes. For European and other international installations, use CENELEC harmonized type

cable, with 1.31 mm² wire size or equivalent, with brown, light blue, and green/yellow stripe color

codes. Power cable must be wired to the DIN-mounted terminal blocks marked 1 (AC live In), 3 (AC

neutral In), and 5 (AC ground). The cable must be fed through one of the cable grips (second cable grip

is recommended).

Interfacing to Analog Output

The optional analog outputs can be voltage or

current depending on the ordered configuration. The

analog output cable should be fed through one of

the cable grips (fourth cable grip is recommended).

Channel 1 output should be wired to the DIN-

mounted terminal blocks marked 14 (positive) and

15 (negative). Isolation option on the analog outputs

is available upon request. Refer to Analog Output

chapter for setup information.

CAUTION: Do not connect to AC power without a proper grounding connection.

Analog output cable installation

North American power cable installation

European and other international power cable installation

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Pas de commentaire

Cosa-xentaur Xentaur XDTL-HT Manuel d'utilisateur Page 13